I contacted Kerry at Sonex concerning the tight bend angles for my main spar and forward spar channels. He indicated that they were indeed tight but that there will be very little load at the tips and therefore these were not a concern. He suggested I use the hand seamer next time for these bends. I proceeded to fabricating the ribs and brackets for the horizontal stablizer.
Disclaimer This web site is in no way a publication of Sonex-Ltd. or any other corporation. All products mentioned are not necessarily recommended for use, but are included for informational purposes only. Builders tips and instructions are not meant to replace the plans and instructions from Sonex-Ltd.. All Builder's tips and instructions are presented only as a source of information and a forum for exchange and the sharing of ideas and construction methods. NO responsibility or liability is assumed, expressed, or implied as to the suitability, accuracy, safety, or approval thereof. Anyone using the suggestions, ideas, instructions or examples on these pages does so at their own risk and discretion and without recourse against anyone. Any material from this page may be reprinted without permission for non-commercial use, but please give credit to the author. Re-use of any material from the pages within this web site (text or graphics) for commercial gain is prohibited without prior written permission from the web page administrator or the author or owner of the materials found on this web site.